Changing A Parameter Setting; About Configuration Parameters - Intermec 700 Series User Manual

Control Panel Applets

Changing a Parameter Setting

Menus of available parameters for each group are listed. Use the scroll bars to
go through the list. Expand each menu (+) to view its parameter settings. Tap a
parameter to select, or expand a parameter (+) to view its subparameters.
Note that each parameter or subparameter is shown with its default setting or
current setting in (< >) brackets. Tap a parameter or subparameter to select
that parameter, then do any of the following to change its setting: Tap Apply to
apply any changes. Note that these illustrations are from a Symbologies parame-
ter.
"
"
"
"
"

About Configuration Parameters

You can find the following information about each configuration parameter:
A-2 700 Series Color Mobile Computer User's Manual
Typing a new value in an entry field.
Choosing a new value from the drop-down list.
Selecting a different option. The selected option contains a bullet.
Tap Defaults, then Apply to restore factory-default settings. Tap Yes
when you are prompted to verify this action.
Tap Refresh to discard changes and start again. Tap Yes when you are
prompted to verify this action.
Name and Purpose:
Describes the parameter and its function.
Action:
Describes what to do with a parameter once that parameter is selected.
SNMP OID:
Lists the SNMP OID for the parameter.
Syntax or Options:
Syntax lists the two-character code for the parameter, if the parameter is
configurable by scanning a bar code or by sending parameters through a
network. Both Syntax and Options list acceptable values for the parame-
ter. Default settings are noted in italic.
APPENDIX A