Intermec 700 Series User Manual page 85

Installing Applications and Updating System Software
6. In the "\2577" directory, add your custom AUTOUSER.DAT file. See the
7. If you are using the RegFlushKey() API, the application must use a special
" NOTE:
If you are using a SecureDigital storage card, you must change any disk access from "Stor-
age Card" to "SDMMC Disk."
8. Remove the storage card from the desktop PC and install the card into the
9. Perform a cold-boot on the 700 Series Color Computer. Files will
When converting a 700 Series Monochrome Computer application to run on the
700 Series Color Computer, most APIs should work without changes. Below are
a few exceptions:
"
"
"
3-10 700 Series Color Mobile Computer User's Manual
Software Tools Help for more information on how to set up an
AUTOUSER.DAT file.
API to make sure the registry is written to the appropriate card; or you can
use the Utilities control panel applet, as follows:
a. From the 700 Series Computer, tap Start → Settings → the Utilities
icon → the Registry Save tab.
b. Tap Enable Registry Storage, then tap either of the following:
Save Registry to SD
To write the registry to the SecureDigital storage card.
Save Registry to CF
To write the registry to the CompactFlash storage card.
c. Tap ok to save your entry and exit the Utilities control panel applet.
700 Series Color Computer.
automatically install from the storage card upon reboot. Any calls to the
RegFlushKey() API will automatically write the registry to the appropriate
location.
The 700 Series Monochrome Computer used the "\Storage Card" folder for
nonvolatile storage. You may need to change the application to store data
in a volatile location or onto the "SDMMC Disk" if a SecureDigital storage
card is present in the system.
If the application uses the RegFlushKey() API, it must first verify that the
proper media is available in the system and call the special API mentioned
in Step 7 on the previous page.
If the application will be using the 700 Color switchable dock, use the API
to set the proper port on the dock before communications.
SECTION 3