Intermec 700 Series User Manual page 107

Network Support
Phone Application
With the WAN radio module installed in your 700 Series Computer, you can send
and receive telephone calls. Use the speaker on the back of the computer as your
earpiece and use the connector on the bottom of the computer for your mouth-
piece.
Tap Phone App from the Details page to access the application which will
process your phone calls. Tap Exit or ok to close this application and return to
the Details page.
"
"
"
"
"
AT Command Interface
This interface specification is based on the following recommendation:
Command Set for CDMA/1xRTT SB555
Use the AT command interface from Sierra Wireless to program the
CDMA/1xRTT SB555. Documentation for this interface is available via the fol-
lowing URL. Click the "General AT command reference" link for a PDF docu-
ment, which is 680 KB in size. Note that this URL is subject to change.
" NOTE:
You will need the Adobe Acrobat Reader application to view this document. Go to
"http://www.adobe.com/prodindex/acrobat/readstep.html" to install or download the latest
Adobe Acrobat Reader according to Adobe's instructions.
4-30 700 Series Color Mobile Computer User's Manual
Tap the numbers for a phone call, using Clear to erase each digit, then tap
Send to initiate the call.
Tap Answer to receive an incoming call.
Tap End to disconnect a transaction.
Tap Vol ^ or Vol v to adjust the speaker volume.
Tap Mic ^ or Mic v to adjust the microphone sensitivity.
ETSI GSM 07.05:
European Digital Cellular Telecommunication System (phase 2)
Use of DTE-DCE interface for Short message and cell broadcast service.
ETSI GSM 07.07:
European Digital Cellular Telecommunication System (phase 2)
AT command set for GSM Mobile Equipment.
ITU-T Recommendation V.25 ter
Serial asynchronous automatic dialing and control.
http://www.sierrawireless.com/ProductsOrdering/embedded_docs.html
SECTION 4