Is9Cconfig2 Functions - Intermec 700 Series User Manual

Scanner Support

IS9CConfig2 Functions

This interface is derived from the IS9CConfig interface and provides additional
methods that can be used to set and retrieve the 700 Series Computer's bar code
configuration. All supported symbologies are initialized to their defaults when
the S9C firmware is loaded.
GET/SET functions use enumerations as their parameters. In most enumera-
tions, there is an enumerator xx_NO_CHANGE (such as
ITC_CODE39_NO_CHANGE), where xx refers to a particular enumeration.
This enumerator can be used during a call to a SET to indicate that no change is
to be made to that particular parameter. This prevents the called function from
having to format the same S9C command and send it down to the scanner.
To specify a bar code length of "any length," use a value of "0" for the bar code
length argument.
IS9CConfig2 functions are the following. IS9CCONFIG.H is the header file and
ITCUUID.LIB contains the IID_IADC Interface GUID value used to obtain the
interface.
"
"
"
"
"
"
"
"
"
"
6-54 700 Series Color Mobile Computer User's Manual
IS9CConfig2::GetCode11 (page 6-55)
IS9CConfig2::SetCode11 (page 6-55)
IS9CConfig2::GetCustomSymIds (page 6-56)
IS9CConfig2::SetCustomSymIds (page 6-56)
IS9CConfig2::GetGlobalAmble (page 6-58)
IS9CConfig2::SetGlobalAmble (page 6-58)
IS9CConfig2::GetPDF417Ext (page 6-59)
IS9CConfig2::SetPDF417Ext (page 6-59)
IS9CConfig2::GetSymIdXmit (page 6-60)
IS9CConfig2::SetSymIdXmit (page 6-60)
SECTION 6