Setting Baud Rate And Parity - Honeywell HD6 Series User Manual

2.2 RECEIVER BOARD SETTINGS, continued

2.2.2 Setting Baud Rate and Parity

The communications baud rate and the parity are set using DIP switch S4 positions
4, 5, 6, and 7. The control system and the scan must be set at the same baud rate and
parity for proper operation. All protocols are set for 8 data bits.
DIP switch 4, position 8 must always be set to OFF.
Baud Rate
2400 Baud
2400 Baud
4800 Baud
4800 Baud
9600 Baud
9600 Baud
19.2K Baud
19.2K Baud
NOTE:
Settings for the protocols are as follows:
Protocol
Honeywell Diamond,
Honeywell Maxpro
Mode, and AD
Honeywell VCL
MUX-100
Pelco P
Pelco D
Rev. 1.02
/ Parity /
/ No Parity /
/ Even Parity /
/ No Parity /
/ Even Parity /
/ No Parity /
/ Even Parity /
/ No Parity /
/ Even Parity /
Baud
9600 baud
9600 baud
19.2k baud
4800 baud
2400 baud
Data Bits S4-5 S4-6
8 data bits OFF OFF
8 data bits OFF OFF
8 data bits ON OFF
8 data bits ON OFF
8 data bits OFF ON
8 data bits OFF ON
8 data bits ON ON
8 data bits ON ON
Even Parity
No Parity
Even Parity
No Parity
No Parity
8
S4-7 S4-8
OFF OFF
ON OFF
OFF OFF
ON OFF
OFF OFF
ON OFF
OFF OFF
ON OFF
Parity
900.0679
22-June-2006