Setting The Dome Address (Sw1 To Sw4); Table 3-6 Dip Switch Sw6 Baud Rate And Parity Settings - Honeywell ACUIX Installation And Configuration Manual

Installation

Setting the Dome Address (SW1 to SW4)

42
Table 3-6 DIP Switch SW6 Baud Rate and Parity Settings
Baud Rate Baud Rate Switch Position
and Parity
Values
1
600 OFF
1200 ON
2400 OFF
4800 ON
9600 OFF
19200 ON
38400 OFF
57600 ON
115200 OFF
None
Even
Odd
* The defaults for SW6-7 and SW6-8 are OFF.
Caution Each dome requires a unique address between 0000 and 9999. The
addressing scheme may be restricted due to the limitations of the
controller. For example, the HEGS5000/HEGS5001 controllers control
dome addresses 1 to 256 whereas the HJZTP controller controls dome
addresses 1 to 128.
1. Turn the arrows on rotary switches SW1, SW2, SW3 and SW4 to the number
required using Table 3-7
• To set the dome address to CAM 0001, set SW1 = 1, SW2 = 0, SW3 = 0,
SW4 = 0.
• To set the dome address to CAM 0125, set SW1 = 5, SW2 = 2, SW3 = 1,
SW4 = 0.
2 3 4
OFF OFF OFF
OFF OFF OFF
ON OFF OFF
ON OFF OFF
OFF ON OFF
OFF ON OFF
ON ON OFF
ON ON OFF
OFF OFF ON
and Figure 3-6 for reference. For example:
Parity Switch Other*
Position
5 6 7
OFF OFF OFF
ON OFF OFF
OFF ON OFF
8
OFF
OFF
OFF