Honeywell HD6 Series User Manual page 48

5.3 CONTROL OPTIONS, CONTINUED
6. Pan Offset – Select 6 to access the Pan
Offset menu.
The pan offset feature is useful when a new scan is installed in a dome and the
programming from the existing scan is transferred to the new scan using the
upload/download feature. The alignment of the new scan may not be exactly the
same as the old scan, causing the programmed positions of the PreShots to be off.
PreShot 0 is used to define the location of the pan setting.
Pan Offset Setup
1. Offset – Select 1 to toggle the offset ON
or OFF. For the scan to adjust the
positioning of the scan to the
programmed pan offset, the offset must
be set to ON.
2. Set Pan Offset – Once Offset is ON,
perform the following steps to set pan
offset:
* You must know the original positioning of PreShot 0.
1. Esc (F6 on the HJZTP controller) out of the HD6 setup menus until you have
2. Send the scan to PreShot 0. If it does not go to the previously known position
3. Using the controller, position the scan for PreShot 0.
4. Access the HD6 MAIN MENU, select 3. Control Options, then select 4. Pan
5. Select 2 to set the pan offset. To test the setting, reposition the scan, the send
Press Esc (F6 on the HJZTP controller) to exit the Pan and Tilt Options menu.
Rev. 1.02
manual control of the scan.
for PreShot 0, the offset function can be used.
Options, and then select 6. Pan Offset.
the scan to PreShot 0. The scan should return to the position programmed in
step 3.
PAN AND TILT OPTIONS
1 Manual Speed deg/s ...................... 400
2 Pan Reverse..................................... Off
3 Tilt Reverse ...................................... Off
4 +2 Deg Tilt Limit.............................. Off
5 Find Home on Startup..................... Off
6 Pan Offset ........................................ Off
ESC to Exit
1 Offset ....................................... ON
2 Set Pan Offset
34
Pan Offset Setup
ESC to Exit
900.0679
22-June-2006