Honeywell HD6 Series User Manual page 45

5.3 CONTROL OPTIONS, CONTINUED
c. Enter a number in the NUM field using the numeric keypad to enter the function #
(P=0-98, V= 0-9, and T=1-3).
d. Press Enter (F5) when finished programming alarms.
See table below for field entry.
Field
FUN (function)
NUM (number)
ENA (enable)
If:
Alarm is disabled
Alarm is enabled and not
programmed
Alarm is enabled and
programmed
Rev. 1.02
Enter function to perform. (P=PreShot, V=VectorScan, T=PTZ Tour.)
Enter the number of the PreShot, VectorScan, or PTZ Tour.
Enter Y to enable or N to disable the alarm.
Then:
The scan ignores a change of state in the alarm input.
The scan ignores a change of state in the alarm input.
The scan performs the action programmed for the alarm input
when a change of state occurs.
Scan adds AL and the alarm number to the video signal.
AL flashes until all alarms are acknowledged.
Alarm status is displayed on-screen on the same line as the
Camera ID display.
Alarm number flashes until the contact returns to its normal
state.
Usage
31 900.0679
22-June-2006