Vectorscan - Honeywell HD6 Series User Manual

5.9 FUNCTION PROGRAMMING, CONTINUED

5.9.2 VectorScan

This menu option is only displayed when
Honeywell Maxpro mode, Honeywell VCL,
Pelco P, Pelco D, or American Dynamics
protocol is selected on the DIP switch on the
scan.
Position the cursor on 2 and press
Iris Open to program a VectorScan.
VectorScans 0-9 can be programmed and assigned to alarms or the default function.
VectorScans 1, 2, & 3 can be started using PreShot commands 87, 88, and 89
respectively.
Press Iris Open when done
1. Use the tilt up function on the joystick until the desired VectorScan number (0-9) is
displayed, then press Iris Open.
2. Use the tilt up and down and the pan left and right functions of the controller to
move between fields.
FIELD
NUM (number)
PRESHOT
VELOCITY
DWELL
Rev. 1.02
Program VectorScan •
↑↓ to scroll
Move the cursor to the desired field and press Iris Open to activate.
Use the tilt up and down functions of the controller to change the value.
If the field is more than one digit, each digit can be changed
individually by placing the cursor on the digit and using the tilt up or
down function.
Selectable from 0 to 79. PreShots 80-99 are reserved for special
functions and cannot be entered in a VectorScan. When the field has
the desired number, press the Iris Open to select the number.
Iris Open also moves the cursor to the next field
The Velocity field is the pan and tilt speed for the scan to go to the
PreShot (1 to 400°/second.) The default is 400°/second.
The dwell time is how long the scan waits before it goes to the next
PreShot in the list (0 to 99 seconds.)
FUNCTION PROGRAMMING
1 PTZ Tour
2 VectorScan
Program VectorScan n
NUM PRESHOT VELOCITY
1 __
2 __
3 __
4 __
5 __
6 __
7
D = Delete
Usage
69
DWELL
__ __
__ __
__ __
__ __
__ __
__ __
__ __
E=Exit S=Save
900.0679
22-June-2006