Section 10: Operation Using American Dynamics Control System; Introduction; Reset Hd6; Controlling Scan Assemblies - Honeywell HD6 Series User Manual

OPERATION USING AMERICAN DYNAMICS CONTROL SYSTEM

10.1 INTRODUCTION

This section provides information on any differences to the material provided for
standard Honeywell Diamond protocol and provides information specific to operation
American Dynamics control systems. Operation of the unit is the same as described in
Section
numbering in Section 6. Therefore, Section 10.3 provides additional or replacement
information to that in Section 6.3.

10.2 RESET HD6

No changes or supplemental instructions are required. Refer to

10.3 CONTROLLING SCAN ASSEMBLIES

• When using an American Dynamics control system, there are several PreShots
(views or presets) reserved for controlling the scan. Refer to
the preprogrammed PreShots and their functions.
• The lens iris is automatically controlled by the camera, but can be controlled
manually from a controller.
The camera lens auto exposure mode can be enabled or disabled using the
•
controller. PreShot 64 toggles the unit between auto and manual exposure. A
message "AUTO EXPOSURE ON" or "AUTO EXPOSURE OFF" is displayed on the
video when the scan executes PreShot 64.
Manual lens exposure control is the factory default for scans set for an American
•
Dynamics control system.
Rev. 1.02
SECTION 10:
NOTE:
• Refer to Section 6
(programming) when using standard Honeywell
Diamond protocol.
• Refer to Section 8
(programming) when using Honeywell Maxpro
mode, Honeywell VCL, Pelco P Code, or Pelco D
Code control systems.
6, with the following statements. The section number corresponds to the
(operation) and Section 7
(operation) and Section 9
103
Section 6.2.
Table 3 for a listing of
900.0679
22-June-2006