Section 11: Programming Using American Dynamics Control System; Introduction; Programming Preshots; Programming Vectorscans - Honeywell HD6 Series User Manual

PROGRAMMING USING AMERICAN DYNAMICS CONTROL SYSTEM

11.1 INTRODUCTION

This section provides information on any differences to the material provided for
standard Honeywell Diamond protocol and provides information specific to operation
with American Dynamics control systems. Programming of the unit is the same as
described in
to the numbering in Section 7. Therefore, Section 11.6 provides additional or
replacement information to that in Section 7.6.

11.2 PROGRAMMING PRESHOTS

Refer to the American Dynamics Controller user's manual for programming views.

11.3 PROGRAMMING VECTORSCANS

VectorScans must be programmed through the setup menu. Send the HD6 to PreShot
61 to access the setup menu. Refer to

11.4 PROGRAMMING SECTOR IDS

This feature is not available when using an American Dynamics control system.

11.5 PROGRAMMING PRIVACY ZONES

This feature is not available when using an American Dynamics control system.

11.6 PROGRAMMING PTZ TOURS

PreShots 21, 22, and 23 have been reserved for programming PTZ tours 1, 2, and 3.
1. Enter a PreShot 21 command on the system controller to program PTZ tour 1.
(Enter a PreShot 22 command for PTZ tour 2 or PreShot 23 command for
PTZ tour 3.)
2. During the 120 second countdown, pan and tilt the scan and adjust the lens zoom
setting. The scan scores the PTZ commands in the order they were performed
during the 120 seconds.
Rev. 1.02
SECTION 11:
Section 7, with the following statements. The section number corresponds
109
Section 5.7.2.
900.0679
22-June-2006