Oce Arizona 200 GT User Manual page 275

Attention:
If you touch the UV lamps with your bare fingers while replacing them, compounds from
your skin can etch the surface and decrease UV transmission, which will shorten the
useful life of the lamp.
Caution:
The UV lamps and the carriage guard may be hot if the printer has been active. Avoid
touching the guard and the lamp assembly until it is cool.
Caution:
These UV lamp bulbs contain mercury, and if they are broken the vapor is toxic if inhaled.
The lamp bulbs must be disposed of according to local environmental regulations.
How to Remove the Lamp Housing
Remove the safety fence by lifting it straight up and then away from the carriage.
1.
Disconnect the UV lamp housing power cable connector by pressing in the two blue tabs
2.
on either side and pull it out.
[195] Disconnect power cable
Remove the foam filter from the top of the housing.
3.
How to Change a UV Lamp Bulb
Chapter 12 - Printer Maintenance 275