Oce Arizona 200 GT User Manual page 88

How to Power the Printer On and Off
3 to 14 days
Longer than 14 days
Note:
Avoid Extended Power Off
If the power is switched off for only a short period (for example, when the printer is shut
down and then immediately restarted to correct an electrical problem or other trou-
bleshooting), no special action is required at startup. However, if it is necessary to leave
the printer idle for an extended period refer to the table above. Also, perform Printhead
Maintenance and Swab the printheads when you start to use it again. We recommend
that you leave the printer powered On at all times except for maintenance or repair.
How to Lock Out the Power Switch
Attention:
Some service procedures require locking out the On/Off switch to ensure operator safety.
When the switch is locked out, it is impossible to supply power to the printer.
Refer to the Shutdown procedure "How to Power Off", at the beginning of this section.
1.
Turn the AC power switch to the Off position.
2.
Apply a lock and a tag-out label to the Lock-out area of the switch for the duration of
3.
any service or maintenance procedures.
Perform service procedure (generally this is done by a service technician)
4.
When maintenance or service is complete, remove the lock and tag-out label and turn
5.
the AC power switch to the On position.
88 Chapter 5 - How to Operate the Océ Arizona 200/250/300/350 GT
Turn off lamps
Wait for the ink temperature to reach at least 40° Centi-
grade -104° Fahrenheit)
Perform printhead maintenance
Swab printheads
Turn off ink heater
Wait until ink cools to below 30°C, then close off all
purge valves on the carriage
If the automatic printer warm-up was set in Printer Set-
tings, turn it off
Remove or rewind any media from the RMO
Contact your local service representative if you need to
prepare the printer for longer term storage