Oce Arizona 200 GT User Manual page 249

Switch 2 to raise carriage
2.
Switch 3 to activate suction pump
3.
Illustration
[179] Maintenance Station Switches
How To Perform Maintenance
Verify that the ink temperature is at least 40° Centigrade (104° Fahrenheit) before you
1.
begin printhead maintenance.
Slide the cover out from under the carriage to reveal the maintenance station.
2.
Press and release switch 1 to initiate a purge. The carriage will lower to its purge height
3.
(4mm above the table surface). Watch the ink as it falls from the heads. After a few seconds
most of the ink stops dripping and you can then raise the carriage.
Press switch 2 to raise the carriage to its maximum height.
4.
Attention:
Be careful not to snag the coiled suction-head hose when removing the suction-head from
the holder.
Printhead Maintenance
Chapter 12 - Printer Maintenance 249