Clean Uv Lamp Filters - Oce Arizona 200 GT User Manual

Clean UV Lamp Filters

Clean UV Lamp Filters
Introduction
The top of the assemblies that house the left and right UV lamp cartidges contains a filter
that can cause overheating of the lamps if it becomes clogged with dust or debris.
When to do
Check the condition of the filters weekly and clean them as needed. If dust accumulates,
this can lead to overheated lamps and results in an error message. It is best to clean the
filters periodically to avoid overheating, but if you do receive an error, check for dust or
debris. If you get a lamp overheat error and there is no dust on the filter, call for service
immediately.
Required tool
Toothbrush (or similar brush device)
Handheld Vacuum appliance
Attention:
Failure to clean the filters can lead to overheating of the lamps and can result in a shorter
lamp life.
Attention:
Do not remove the filters and do not diassemble the lamp cartridge due the danger of
high voltage power.
How to Clean the UV Lamp Filters
If there is any dust or debris on the surface of the filter, use vacuum cleaner to remove it.
1.
Use a small brush to loosen any dust or debris that is embedded in the mesh of the filter.
2.
Use the vacuum cleaner to remove any material loosened in step 2.
3.
258 Chapter 12 - Printer Maintenance