Oce Arizona 200 GT User Manual page 69

The operator can automatically set the status of a job to Hold when the job is put in
this queue. This can be set separately for flatbed and roll media jobs.
9) Job information and parameters panel
The job information area displays only relevant job parameters of the current print job.
For example, the Overprints field is not displayed for roll media jobs. Some of the param-
eters may be modified.
#
Offsets A job's vertical and horizontal offset parameters can be
changed with the mouse wheel when mouse cursor is posi-
tioned over the field. Rotate the mouse wheel up or down
increments or decrements offset at the rate of one unit per
notch. Hold the right mouse button and rotate the wheel
increments or decrements at the rate of 10 units per notch.
An alternate method to change parameter values is to click
on the field and this brings up an onscreen keyboard so you
can click on the numbers required. You can also use Preview
to drag an image to the desired position.
Chapter 4 - How to Navigate the User Interface
Print Job Control Module
69