Oce Arizona 200 GT User Manual page 248

Printhead Maintenance
this position as this will disable the ink pumps and thus prevent the performance of an
ink purge, which is necessary for printhead maintenance.
Note:
It is not necessary to turn off the UV lamps as they are shuttered. However, they will
be hot if they are on, so avoid touching them.
Ink must be at the operating temperature of at least 40° Centigrade (104° Fahrenheit)
before you perform printhead maintenance. The Job Control module displays the ink
temperature. If the temperature is low, activate the ink heater by clicking the icon and
then monitor the temperature display.
Required tool
3010104959 Cloth-Poly Wipe 10cmX10cm
Note:
Safety glasses with side shields, a protective apron, and nitrile gloves must be worn when
performing maintenance.
Caution:
The underside of the UV lamps may be hot, avoid touching them. Also, be aware that
the carriage moves up and down during printhead maintenance and there is a crushing
hazard if your hand or arm are placed in the area above the three switches.
Attention:
Do NOT press up too hard on the printhead while you swipe it with the suction-head
as this can dislodge the printhead and require a service call to re-seat the printhead.
Note:
Maintenance Station Switches:
There are 3 switches inside of the maintenance station . They can be operated in any
order. For example, you can press the second switch to raise the carriage to remove debris
from the underside of the carriage even when a purge isn't required.
Switch 1 to purge ink
1.
248 Chapter 12 - Printer Maintenance