Safety Awareness - Oce Arizona 200 GT User Manual

Safety Awareness

Safety Awareness
Introduction
This section contains two sets of principles that must be followed to assure maximum
safety when operating the Océ Arizona 200/250/300/350 GT printer. The first set uses
negative examples to show you residual risks to avoid in order to prevent injury to the
operator. The second set of principles illustrates some of the residual risks that are inherent
in the operation of the printer. These are situations or physical aspects of the printer that
may present a potential danger to the operator, but would compromise the capabilities
of the printer if changed. Therefore, they are pointed out as a precaution the operator
must be aware of when using the printer.
Attention:
The photos in the following table illustrate residual risks that must be avoided when op-
erating the Océ Arizona 200/250/300/350 GT printer.
Situations and Actions to Avoid
How NOT to use the printer
Avoid these Situations For Your Personal Safety
[27] Keep the table clear
40 Chapter 3 - Safety Information
#
Do not place your
hand in the carriage
pathway when printer
power is on. Do not
leave any objects on
the table printing sur-
face, except for media
that you will print on.
Also make sure the
media is 48 mm (1.89
inches) or less in
thickness.