Oce Arizona 200 GT User Manual page 87

How to Power Off
Attention:
To maintain optimal printer reliability, leave the power on at all times. However, there
are exceptions such as for ink flushes, some service procedures, or if the printer requires
a reboot.
If you need to shut down the printer for just a few minutes, follow this procedure.
However, if you need to leave the printer idle for periods of 30 minutes to 14 days, see
the table below.
Turn off the UV lamps.
1.
Wait for the lamps to cool down (fans will stop).
2.
Click on the Shutdown icon in the Tools and Utilities tab to exit the printer software.
3.
Turn the AC power switch to the OFF position.
4.
Turn the power back on when the service or procedure is complete.
5.
How to prepare the printer for idle periods:
Note:
Do not turn off the printer during these idle times.
#
15 to 30 minutes
30 minutes to 24 hours
24 to 72 hours
Turn off lamps
Turn of lamps
Turn off ink heater
Turn off lamps
Wait for the ink temperature to reach at least 40° Centi-
grade -104° Fahrenheit)
Perform printhead maintenance
Swab print heads
Turn off ink heater
If the automatic printer warm-up was set in Printer Set-
tings, turn it off
Chapter 5 - How to Operate the Océ Arizona 200/250/300/350 GT
How to Power the Printer On and Off
87