Oce Arizona 200 GT User Manual page 67

Ink Tempera- This button controls the ink heater and also displays the ink tem-
ture Control perature. The state of the button reflects the status of the ink heater.
The heater times out after two hours of inactivity (time can be
changed up to four hours by a service technician). If the ink heater
is turned off when the timeout period has expired, the button
changes its status to unchecked.
The print heads must be at operating temperature (47°C - 116°F)
before a job will start printing.
UV Curing This button controls the UV curing lamps. The state of the button
Lamp Control reflects the state of the lamps. The UV lamps will timeout after 15
Button minutes of inactivity (time can be changed by a service technician).
If lamps are extinguished when the timeout expired, then the button
change its status to unchecked. If lamps are off before the print
starts, then lamps are turned on automatically and the button would
reflect the state accordingly.
Table vacuum This button controls the table vacuum and duplicates the function
button of the table vacuum foot switch. The button reflects the actual state
of the table vacuum. There is an automatic timeout that will turn
the table vacuum off. The actual time is set in the Settings module
under printer.
Start Button This icon can be used to start a flatbed print job (same function as
the physical button on the table).
Nozzle check This button populates the active job list with a job that prints a
nozzle check pattern. The nozzle check print is used to identify
nozzle dropouts that can cause banding and other print quality
problems.
6) Active Print Job List
The active job list consists of a table, job count summary on top and job order control
buttons on the left. A job count summary displays total number of active jobs and number
of jobs put on hold. Job order control buttons can be used to change order of jobs queued
for printing. The active job list has the following features:
Note:
This button may also indicate an error
Note:
Once turned off, vacuum cannot be turned on again for
approximately 5 seconds.
Chapter 4 - How to Navigate the User Interface
Print Job Control Module
67