Oce Arizona 200 GT User Manual page 107

With the gantry in its home position, carefully lift the overlay up enough to release it
1.
from the two registration pins (the pins are located on the Control side of the table near
the corners of the overlay: the side with the Print button and vacuum gauge).
[73] Registration Pins
With one person at each end, carefully raise the overlay to the upright position on the
2.
Control side edge of the table.
[74] How to Handle the Overlay
Note:
Make sure that you support the middle parts of the overlay so that you don't bend or
warp it, as shown in the photo. If it does warp you may have to turn it over and leave it
to settle for a while until it is completely flat.
With one hand on the top and the other on the bottom, carefully flip the overlay over
3.
and lay it down flat on the table (or another clean, flat surface).
Chapter 5 - How to Operate the Océ Arizona 200/250/300/350 GT
How to Create Custom Vacuum Zones
107