Yamaha TT-R125(W) Owner's Service Manual page 356

Å
CLUTCH AND PRIMARY DRIVEN GEAR
ı
Clutch
1. Install:
Conical spring washer 1
G
Thrust plate 2
G
Primary driven gear 3
G
Thrust plate 4
G
Clutch boss 5
G
2. Install:
Lock washer
G
Nut (clutch boss) 1
G
NOTE:
Use the clutch holding tool 2 to hold the clutch
boss.
Clutch holding tool:
YM-91042/90890-04086
Å For USA and CDN
ı Except for USA and CDN
3. Bend:
Lock washer tab
G
4. Install:
Friction plate 1
G
Clutch plate 2
G
NOTE:
Install the clutch plates and friction plates
G
alternately on the clutch boss, starting with a
friction plate and ending with a friction plate.
Apply the engine oil on the friction plates and
G
clutch plates.
Be sure to install a clutch plate with projec-
G
tion a offset approximately 90˚ from previ-
ous plates
procedure in a clockwise direction until all
clutch plates are installed.
4 - 46
ENG
New
60 Nm (6.0 m · kg, 43 ft · lb)
projection. Continue this