Yamaha TT-R125(W) Owner's Service Manual page 162

After connecting the
switch coupler, engine stop
switch coupler, clutch switch
coupler and start switch cou-
pler, put a connector cover on
the couplers and push them in
at the rubber cover end.
Pass the wire harness on the
outside of the main switch cou-
pler.
Do not allow the primary coil
lead to slacken where it is bare
of the protecting tube.
CABLE ROUTING DIAGRAM
main Fasten the CDI unit lead and
starting circuit cut-off relay lead
with a plastic locking tie at the
tape holding the main switch
lead, engine stop switch lead,
clutch switch lead, and start
switch lead together.
Position the starter cable, throt-
tle cable, CDI magneto lead,
wire harness and rear shock
absorber
hose (TT-R125LWE only) as
shown.
S
R
P
Q
O
N
M
assembly sub-tank
D
E
D
AB
A
Y
A
2 - 32
SPEC
Fasten the wire harness, throttle
cable, starter cable, CDI mag-
neto lead and rear
absorber assembly
hose (TT-R125LWE only) at the
protecting tube for the CDI mag-
neto lead.
Fasten the rectifier/regulator
A A
lead as shown.
Do not allow the CDI magneto
A B
lead to slacken.
Position the plastic locking tie
A C
ends as shown.
C
À
D
B
G G G G G G
E
C
F
K
L
shock
sub-tank
H
I
J