Jumboframe Enable; Link-Delay - HP 3600 v2 Series Command Reference Manual

jumboframe enable

Syntax
jumboframe enable [ value ]
undo jumboframe enable
View
Ethernet interface view, port group view
Default level
2: System level
Parameters
value: Sets the maximum length of Ethernet frames that are allowed to pass through, ranging from 1536
to 10000 bytes. If you set the value argument multiple times, the latest configuration takes effect.
Description
Use jumboframe enable to allow jumbo frames within the specified length to pass through one or
multiple Ethernet interfaces.
Use undo jumboframe enable to prevent jumbo frames from passing through one or multiple Ethernet
interfaces.
By default, the switch allows jumbo frames within 10000 bytes to pass through Ethernet interfaces.
In Ethernet interface view, the command applies only to the current Ethernet interface.
In port group view, the command applies to every Ethernet interface in the port group.
Examples
# Configure the switch to allow jumbo frames within 10000 bytes to pass through Ethernet 1/0/1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] jumboframe enable

link-delay

Syntax
link-delay delay-time
undo link-delay
View
Ethernet interface view
Default level
2: System level
Parameters
delay-time: Sets the physical state change suppression interval on the Ethernet interface, ranging from 2
to 10 seconds.
Description
Use link-delay to set the physical state change suppression interval on an Ethernet interface.
20