Link-Delay - HP A5830 Series Command Reference Manual

View
Ethernet interface view, port group view
Default level
2: System level
Parameter
value: Sets the maximum length of Ethernet frames that are allowed to pass through, ranging from 1536
to 9216 bytes. If you set the value parameter multiple times, the latest configuration takes effect.
Example
# Configure the switch to allow jumbo frames within 9216 bytes to pass through GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] jumboframe enable

link-delay

Description
Use the link-delay command to set the physical state change suppression interval on an Ethernet
interface.
Use the undo link-delay command to restore the default.
By default, physical state change suppression is disabled on Ethernet interfaces.
Do not use this command on Ethernet interfaces with RRPP, MSTP, or Smart Link enabled.
This command does not apply to ports that are shut down administratively (with the shutdown command).
Syntax
link-delay delay-time
undo link-delay
View
Ethernet interface view
Default level
2: System level
Parameter
delay-time: Sets the physical state change suppression interval on the Ethernet interface, ranging from 2
to 10 seconds.
Example
# Enable physical state change suppression on GigabitEthernet 1/0/1, setting the suppression interval to
8 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] link-delay 8
19