Dldp Configuration Task List; Configuring The Duplex Mode And Speed Of An Ethernet Interface - HP 6125G Configuration Manual

Table 17 Description on DLDP neighbor states
DLDP neighbor state
Unknown
Two way
Unidirectional

DLDP configuration task list

For DLDP to work properly, enable DLDP on both sides and make sure these settings are consistent: the
interval to send Advertisement packets, DLDP authentication mode, and password.
DLDP does not process any link aggregation control protocol (LACP) events. The links in an aggregation
are treated as individual links in DLDP.
Make sure the DLDP version running on devices on the two ends are the same.
Complete the following tasks to configure DLDP:
Task

Configuring the duplex mode and speed of an Ethernet interface

Enabling DLDP
Setting DLDP mode
Setting the interval to send advertisement packets
Setting the delaydown timer
Setting the port shutdown mode
Configuring DLDP authentication
Resetting DLDP state
Configuring the duplex mode and speed of an
Ethernet interface
To make sure that DLDP works properly on a link, you must configure the full duplex mode for the ports
at two ends of the link, and configure a speed for the two ports, rather than letting them negotiate a
speed.
For more information about the duplex and speed commands, see Layer 2—LAN Switching Command
Reference.
Description
A neighbor is in this state when it is just detected and is being probed. A neighbor is
in this state only when it is being probed. It transits to Two way state or Unidirectional
state after the probe operation finishes.
A neighbor is in this state after it receives response from its peer. This state indicates
the link is a two-way link.
A neighbor is in this state when the link connecting it is detected to be a unidirectional
link. After a device transits to this state, the corresponding neighbor entries
maintained on other devices are removed.
35
Remarks
Required
Required
Optional
Optional
Optional
Optional
Optional
Optional