Radius Scheme - HP 6125G Command Reference Manual

vpn-instance vpn-instance-name: Specifies the MPLS L3VPN to which the source IPv4 address belongs,
where vpn-instance-name is a case-sensitive string of 1 to 31 characters. With a VPN specified, the
command specifies a private-network source IPv4 address. With no VPN specified, the command
specifies a public-network source IPv4 address.
Description
Use radius nas-ip to specify a source address for outgoing RADIUS packets.
Use undo radius nas-ip to remove the configuration.
By default, the source IP address of an outgoing RADIUS packet is the IP address of the outbound
interface.
You can specify up to one public-network source IP address and 15 private-network source IP addresses.
A newly specified public-network source IP address overwrites the previous one. Each VPN can have only
one private-network source IP address. A private-network source IP address newly specified for a VPN
overwrites the previous one.
The source IP address of RADIUS packets that a NAS sends must match the IP address of the NAS that
is configured on the RADIUS server. A RADIUS server identifies a NAS by its IP address. Upon receiving
a RADIUS packet, a RADIUS server checks whether the source IP address of the packet is the IP address
of any managed NAS. If yes, the server processes the packet. If not, the server drops the packet.
The setting configured by the nas-ip command in RADIUS scheme view is only for the RADIUS scheme,
whereas that configured by the radius nas-ip command in system view is for all RADIUS schemes. The
setting in RADIUS scheme view takes precedence.
Related commands: nas-ip.
Examples
# Set the IP address for the switch to use as the source address of the RADIUS packets to 129.10.10.1.
<Sysname> system-view
[Sysname] radius nas-ip 129.10.10.1

radius scheme

Syntax
radius scheme radius-scheme-name
undo radius scheme radius-scheme-name
View
System view
Default level
3: Manage level
Parameters
radius-scheme-name: RADIUS scheme name, a case-insensitive string of 1 to 32 characters.
Description
Use radius scheme to create a RADIUS scheme and enter RADIUS scheme view.
Use undo radius scheme to delete a RADIUS scheme.
By default, no RADIUS scheme is defined.
53