Mac-Forced-Forwarding Network-Port - HP 6125G Command Reference Manual

Parameters
None
Description
Use mac-forced-forwarding gateway probe to enable periodic gateway MAC address probe. The probe
interval is 30 seconds, and the probe mode can be manual or automatic.
Use undo mac-forced-forwarding gateway probe to restore the default.
By default, periodic gateway MAC address probe is disabled.
Make sure you have enabled MFF before enabling periodic gateway MAC address probe.
Examples
# Enable periodic gateway MAC address probe.
<Sysname> system-view
[Sysname] vlan 1
[Sysname-vlan1] mac-forced-forwarding gateway probe

mac-forced-forwarding network-port

Syntax
mac-forced-forwarding network-port
undo mac-forced-forwarding network-port
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use mac-forced-forwarding network-port to configure the Ethernet port as a network port.
Use undo mac-forced-forwarding network-port to restore the default.
By default, the port is a user port.
The upstream ports connecting to a gateway or the ports between devices in a ring network should be
configured as network ports. You can configure multiple ports as network ports.
You can configure a port as a network port regardless of whether MFF is enabled for the VLAN of the
port; however, the configuration takes effect only after MFF is enabled.
Link aggregation is supported by network ports in an MFF-enabled VLAN, but is not supported by user
ports in the VLAN. If a network port is added to a link aggregation group belonging to an MFF-enabled
VLAN, you need to remove the network port from the link aggregation group before you can cancel the
network port configuration. For more information about link aggregation, see Layer 2—LAN Switching
Configuration Guide.
Examples
# Configure GigabitEthernet 1/0/1 as a network port.
274