Sftp Client Source - HP 6125G Command Reference Manual

Parameters
ipv6 ipv6-address: Specifies a source IPv6 address.
interface interface-type interface-number: Specifies a source interface by its type and number.
Description
Use sftp client ipv6 source to specify the source IPv6 address or source interface for an SFTP client.
Use undo sftp client ipv6 source to remove the configuration.
By default, an SFTP client uses the IPv6 address of the interface specified by the route of the device to
access the SFTP server.
To make sure the SFTP client and the SFTP server can communicate with each other, and to improve the
manageability of SFTP clients in the authentication service, HP recommends you specify a loopback
interface as the source interface.
Related commands: display sftp client source.
Examples
# Specify the source IPv6 address of the SFTP client as 2:2::2:2.
<Sysname> system-view
[Sysname] sftp client ipv6 source ipv6 2:2::2:2

sftp client source

Syntax
sftp client source { ip ip-address | interface interface-type interface-number }
undo sftp client source
View
System view
Default level
3: Manage level
Parameters
ip ip-address: Specifies a source IPv4 address.
interface interface-type interface-number: Specifies a source interface by its type and number.
Description
Use sftp client source to specify the source IPv4 address or interface of an SFTP client.
Use undo sftp client source to remove the configuration.
By default, an SFTP client uses the IP address of the interface specified by the route of the device to access
the SFTP server.
To make sure the SFTP client and the SFTP server can communicate with each other, and to improve the
manageability of SFTP clients in the authentication service, HP recommends you specify a loopback
interface as the source interface.
Related commands: display sftp client source.
Examples
# Specify the source IP address of the SFTP client as 192.168.0.1.
228