Reset Dot1X Statistics - HP 6125G Command Reference Manual

The unicast trigger function enables the network access device to initiate 802.1X authentication when it
receives a data frame from an unknown source MAC address. The device sends a unicast Identity
EAP/Request packet to the unknown source MAC address, and retransmits the packet if it has received
no response within a period of time (set with the dot1x timer tx-period command). This process continues
until the maximum number of request attempts (set with the dot1x retry command) is reached.
Related commands: display dot1x, dot1x timer tx-period, and dot1x retry.
Examples
# Enable the unicast trigger function for interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dot1x unicast-trigger

reset dot1x statistics

Syntax
reset dot1x statistics [ interface interface-list ]
View
User view
Default level
2: System level
Parameters
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1- 1 0>, where interface-type represents the port type,
interface-number represents the port number, and & <1- 1 0> means that you can provide up to 10 ports
or port ranges. The start port number must be smaller than the end number and the two ports must be of
the same type.
Description
Use reset dot1x statistics to clear 802.1X statistics.
If a list of ports is specified, the command clears 802.1X statistics for all the specified ports. If no ports are
specified, the command clears all 802.1X statistics.
Related commands: display dot1x.
Examples
# Clear 802.1X statistics on port GigabitEthernet 1/0/1.
<Sysname> reset dot1x statistics interface gigabitethernet 1/0/1
111