Dot1X Max-User - HP 6125G Command Reference Manual

[Sysname-GigabitEthernet1/0/1] dot1x mandatory-domain my-domain
# After 802.1X user usera passes the authentication, execute the display connection command to display
the user connection information on GigabitEthernet 1/0/1. For more information about the display
connection command, see
[Sysname-GigabitEthernet1/0/1] display connection interface gigabitethernet 1/0/1
Slot: 1
Index=68
IP=3.3.3.3
IPv6=N/A
MAC=0015-e9a6-7cfe
Total 1 connection(s) matched on slot 1.
Total 1 connection(s) matched.

dot1x max-user

Syntax
In system view:
dot1x max-user user-number [ interface interface-list ]
undo dot1x max-user [ interface interface-list ]
In Ethernet interface view:
dot1x max-user user-number
undo dot1x max-user
View
System view, Ethernet interface view
Default level
2: System level
Parameters
user-number: Specifies the maximum number of concurrent 802.1X users on a port. The value is in the
range of 1 to 2048.
interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list argument is in the format of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } & <1- 1 0>, where interface-type represents the port type,
interface-number represents the port number, and & <1- 1 0> means that you can provide up to 10 ports
or port ranges. The start port number must be smaller than the end number and the two ports must be of
the same type.
Description
Use dot1x max-user to set the maximum number of concurrent 802.1X users on a port.
Use undo dot1x max-user to restore the default.
By default, the maximum number of concurrent 802.1X users on a port is 2048.
In system view:
If you do not specify the interface-list argument, the command applies to all ports.
•
"AAA configuration
,Username=usera@my-domian
commands."
103