Use undo accounting-on enable to disable the accounting-on feature.
By default, the accounting-on feature is disabled.
Parameters set with the accounting-on enable command take effect immediately.
After executing the accounting-on enable command, issue the save command to make sure that the
command takes effect after the switch reboots. For information about the save command, see
Fundamentals Command Reference.
Related commands: radius scheme.
Examples
# Enable the accounting-on feature for RADIUS authentication scheme radius1, set the retransmission
interval to 5 seconds, and set the transmission attempts to 15.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] accounting-on enable interval 5 send 15
attribute 25 car
Syntax
attribute 25 car
undo attribute 25 car
View
RADIUS scheme view
Default level
2: System level
Parameters
None
Description
Use attribute 25 car to specify to interpret the RADIUS class attribute (attribute 25) as CAR parameters.
Use undo attribute 25 car to restore the default.
By default, RADIUS attribute 25 is not interpreted as CAR parameters.
Related commands: display radius scheme and display connection.
Examples
# Specify to interpret RADIUS attribute 25 as CAR parameters.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] attribute 25 car
data-flow-format (RADIUS scheme view)
Syntax
data-flow-format { data { byte | giga-byte | kilo-byte | mega-byte } | packet { giga-packet |
kilo-packet | mega-packet | one-packet } } *
37