Dot1X Multicast-Trigger - HP 6125G Command Reference Manual

If you specify the interface-list argument, the command applies to the specified ports.
•
In Ethernet interface view, the interface-list argument is not available and the command applies to only
the Ethernet port.
Related commands: display dot1x.
Examples
# Set the maximum number of concurrent 802.1X users on port GigabitEthernet 1/0/1 to 32.
<Sysname> system-view
[Sysname] dot1x max-user 32 interface gigabitethernet 1/0/1
Or
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] dot1x max-user 32
# Configure GigabitEthernet 1/0/2 through GigabitEthernet 1/0/5 each to support a maximum of 32
concurrent 802.1X users.
<Sysname> system-view
[Sysname] dot1x max-user 32 interface gigabitethernet 1/0/2 to gigabitethernet 1/0/5

dot1x multicast-trigger

Syntax
dot1x multicast-trigger
undo dot1x multicast-trigger
View
Ethernet interface view
Default level
2: System level
Parameters
None
Description
Use dot1x multicast-trigger to enable the 802.1X multicast trigger function. The device acts as the
initiator and periodically multicasts Identify EAP-Request packets out of a port to detect 802.1X clients
and trigger authentication.
Use undo dot1x multicast-trigger to disable the function.
By default, the multicast trigger function is enabled.
You can use the dot1x timer tx-period command to set the interval for sending multicast Identify
EAP-Request packets.
Related commands: display dot1x.
Examples
# Enable the multicast trigger function on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
104