Packing A Sip For Shipment - Cisco 7600 series Hardware Installation Manual

Packing a SIP for Shipment

Packing a SIP for Shipment
This section provides step-by-step instructions for packing a SIP for shipment. Before beginning this
procedure, you should have the following original Cisco Systems packaging materials:
•
•
•
•
Use Cisco Systems original packaging for the shipment of all SIPs. Failure to properly use Cisco
Caution
Systems packaging can result in damage or loss of product.
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
These instructions assume that the SIP has been removed from the router according to the recommended
Note
procedures specified in this guide.
To pack a SIP for shipment, follow these steps:
Insert the SIP into the static shielding bag.
Step 1
Insert the bagged SIP into the smaller inner carton. Be careful to position the SIP so that the bottom
Step 2
motherboard lip is held by the packaging cutout.
Close the smaller inner carton and tape the sides closed.
Step 3
Step 4 Place the sealed smaller inner carton containing the SIP into the two foam packing cushions (they only
fit one way).
Place the sealed smaller inner carton and packing cushions into the larger exterior carton, and seal the
Step 5
larger exterior carton with tape for shipment.
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
7-4
Static shielding bag
Smaller inner carton
Larger exterior carton
Two foam packing cushions
Chapter 7 Troubleshooting the Installation
OL-5052-08