Installing A Surface Mount; Description - Bosch VEZ Series Installation Manual

AutoDome Easy II
4

Installing a Surface Mount

4.1

Description

This chapter details how to mount the AutoDome Easy II to a
hard surface. The AutoDome Easy II is also suitable for wall
(Section 5 Installing a Wall Mount, page 31), recess
(Section 6 Installing a Recessed Mount, page 42), and pipe
mounting (Section 7 Installing a Pipe Mount, page 50). For
specific directions on mounting the unit, see the manual that
came with your mount.
For an outdoor installation you must obtain the Surface Mount
Junction Box (VEZ-A2-JC or VEZ-A2-JW) and the gaskets and O-
rings supplied with an AutoDome Easy II Outdoor Camera to
ensure a water-tight environment inside the unit and to
maintain an IP Environmental Protection Rating. Refer to
Section 4.1.3 Preparing the Surface Mount for an Outdoor
Installation, page 24, to start an outdoor installation.
NOTICE!
The image sensors in modern CCD cameras are highly sensitive
and require special care for proper performance and extended
lifetime. Follow the guidelines for optimum results with your
camera:
–
–
Bosch Security Systems, Inc.
Do not expose to direct sunlight or bright spotlights in
operating and nonoperating conditions.
Avoid bright lights in the field of view of the camera. Bright
lights cause a "smearing" effect, which is visible as white
lines above and below the highlight. Prolonged exposure to
bright lights may cause bleaching of the sensor's color
filters. This will be visible as colored spots in the picture
and is irreversible.
Installation Manual
Installing a Surface Mount | en
F.01U.164.478 | 2.0 | 2010.02
21