Installing A Surface Mount And Camera; Tools Required; Installation Requirements; Preparing The Surface Mount For Installation - Bosch AUTODOME IP 4000i Installation Manual

AUTODOME IP 4000i
8

Installing a Surface Mount and Camera

8.1

Tools Required

–
–
–
8.2

Installation Requirements

–
–
8.3

Preparing the Surface Mount for Installation

1. Determine the side of the surface mount adapter (NEZ-A4-SMB) from which the external
cables are to be routed. Remove the plug from the appropriate hole in the side of the adapter.
2. Attach a ground wire (user-supplied) to the stand-off on the inside of the adapter with the
ground symbol with one M5 screw.
3. Attach the L-shaped end of the safety tether (supplied with the camera) to the stand-off on
the inside of the adapter with the other M5 screw.
8.4

Installing the Surface Mount Adapter

1.
2.
3.
4.
Bosch Security Systems
Appropriate screwdriver (Phillips head)
Appropriate tool for cutting a hole in drywall or ceiling tile (if applicable)
One (1) ground
The ceiling is thick enough to install the mounting screws.
The ceiling can sustain at least eight (8) times the weight of the camera (1.88 kg (4.14
lb)): > 15 kg (33 lb).
NEZ-A4-SMB
M5
Determine a secure location for mounting the surface mount adapter (NEZ-A4-SMB) and
the camera.
Use the adapter as a template to mark on the mounting surface the locations of the four
holes in which to insert the screws for mounting the adapter.
Drill the four (4) holes in the installation location.
Attach the surface mount adapter to the surface using the four screws.
Installing a Surface Mount and Camera | en
M5
Installation Manual
17
2017.08 | 1.0 | F.01U.xxx.xxx