Connection - NEC Express 5800 User Manual

2-8 Setup

Connection

Connect peripheral devices to NEC Express5800/ft series.
The server is provided with connectors for wide variety of peripheral devices on its front and rear.
The figure below illustrates available peripheral devices for the server in the standard configuration,
and locations of the connectors for the devices. After connecting the peripheral devices, connect the
provided power cord with the server, then plug the power cord into the power outlet.
Observe the following instructions to use the server safely. Failure to follow
these instructions could lead to a death or serious injury. For details, see
"NOTES FOR SAFE HANDLING" in Chapter 1.
Observe the following instructions to use the equipment safely. Failure to follow
these instructions may cause a burn, personal injury, or damage to physical
assets. For details, see "NOTES FOR SAFE HANDLING" in Chapter 1.
IMPORTANT:
Power off the server before connecting peripheral devices, with the exception of peripherals
with USB interface. Connecting a powered peripheral device to the powered server will cause
malfunctions and failures.
To connect a third-party peripheral device or interface cable to the server, check with your
sales agent to see if they are compatible with NEC Express5800/ft series. Some third-party
devices may not be used with the server.
The total cable length of SCSI device connections is up to 6 m, including the internal SCSI
cables.
The serial port connectors are reserved for maintenance.
Do not hold the power plug with a wet hand.
Do not connect the ground wire to a gas pipe.
Do not plug the power cord in a nonconforming outlet.
Do not plug too many cords in a single outlet.
Do not plug the cord insecurely.
Do not use nonconforming power cords.
WARNING
CAUTION