NEC Express 5800 User Manual page 85

Hide thumbs Also See for Express 5800:
Table of Contents

Advertisement

3.
Select [SNMP Service] from the service list and then [Properties] in the [Action] menu.
The "SNMP Properties" dialog box appears.
4.
Enter "public" in the [Community name] box in the [Traps] property sheet and click the [Add
to list] button.
IMPORTANT:
To change the community name of traps to be received from the default "public" in the
NEC ESMPRO Manager site, enter the same name as the community name newly set
in the NEC ESMPRO Manager site.
To receive trap from NEC ESMPRO Agent at the NEC ESMPRO Manager machine,
both community names should be the sam
5.
Click the [Add...] button in [Trap destinations]. After entering the IP address of the NEC
ESMPRO Manager machine of the send destination in the [Host name, IP or IPX address] box,
click the [Add] button.
IMPORTANT:
specified as the trap send destination in the setup of the manager report (TCP/IP), the
message warning the duplication appears. The specification of the same NEC ESMPRO
Manager causes to be reported doubly .
6.
Open [Security] property sheet and make settings as follows;
Add the community name entered in Step 4 to [Accepted community names].
Set its authority to [READ CREATE] or [READ WRITE].
Select [Accept SNMP packets from any host.]
IMPORTANT:
If you entered any community name other than "public" in Step 4, add that name to
"Accepted community names" .
Unless you set the acceptable community's authority to "READ CREATE" or "READ
WRITE," you cannot perform monitoring from NEC ESMPRO Manage
< Setup of receiving SNMP packets from specific hosts only >
Select [Accept SNMP packets from these hosts], specify IP addresses of the hosts, IP
addresses of the servers to install Agent, and the loop-back address (127.0.0.1).
< Setup of receiving SNMP packets from specific communities only >
Change the name of the community receiving SNMP packets from the default "public" to
any name.
IMPORTANT:
If the community name is changed, the community of NEC ESMPRO Agent is
changed and registered by starting from [Control Panel]. To change the community to
another and register it, use the [SNMP Community] list box in the [General] tab.
To allow NEC ESMPRO Agent to receive SNMP packets sent from NEC ESMPRO
Manager, set the send community name in NEC ESMPRO Manager to be the same as
that accepted by the SNMP Service in NEC ESMPRO Agent.
Procedures after Completion of Installation
If the IP address (or host name) of the remote NEC ESMPRO Manager
e.
4-11
r.

Advertisement

Table of Contents
loading

Table of Contents