NEC Express 5800 User Manual page 54

3-14 Windows Setup
2 Make sure that the two BMC status LEDs of the PCI modules (for Group1/for Group2) are
turned off.
IMPORTANT:
While the BMC status LED is red and blinking, do not perform steps (3) and on. Otherwise
the BMC firmware may become damaged.
3 Remove the power cord of the AC inlet A (for Group2).
4 Check that the POWER switch of the PCI module for Group1 is turned on.
5 Connect the power cord of the AC inlet A (for Group2).
6 Make sure that two BMC status LED for PCI modules (for Group 1/for Group 2) are turned
off.
IMPORTANT:
If the BMC status LED is red and blinking, do not start the ft series setup. Otherwise the setup may not
be done properly.
Preparation is now completed. Start the ft series setup.