NEC Express 5800 User Manual page 55

Starting the ft series setup
Follow the steps below to perform ft series setup:
If you skip the settings of "SWITCHING BOOT MONITORING FUNCTION
IMPORTANT:
~CHANGING BIOS SETTINGS~" (page 3-2), BIOS will be restarted forcefully while Windows
setup screen is shown and the setup will be unsuccessful; BIOS may repeat Windows setup in an
invalid manner. In this case, you will need to restart the setup procedures from the beginning.
1. Turn on the peripheral equipment and then the NEC Express5800/ft series.
2. Insert the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.
IMPORTANT:
CD-ROM drive.
3. When having inserted the CD-ROM correctly, reset the system (press Ctrl, Alt and Delete
together), or turn the power off and then turn it on to restart the NEC Express5800/ft series.
The system starts through the CD-ROM, and NEC EXPRESSBUILDER is activated.
4. Click [Setup].
5. When the following message appears, click [Confirm].
Note
We recommend you that you should save the information proper to your
system after system setup.
information. You can save the information by the following process.
(1) Select 'Tools'. (2) Select 'Off-line Maintenance Utility'.
(3) Select 'System Information Management.' (4) Select 'Save'.
For ft series setup, insert the CD-ROM into the PCI module for Group1's
If not, you will not be able to recover the
[Confirm]
Windows Setup 3-15