Problems With Nec Express5800 Ft Series Setup - NEC Express 5800 User Manual

5-18 Troubleshooting

Problems with NEC Express5800 ft series Setup

The following message is displayed when the setup starts.
The specified disk is not found. Terminating SW installation.
→ The disk to install the system is not connected properly. Check if the hardware is
properly installed and connected.
The following message is displayed while copying files from CD-ROM.
xxxxx : Not Ready xxxxxxxxxxxxxxxxxxZ
xxxxx(A), xxxxx(R), xxxxx(F)
→ Press R. If this message still appears, perform the setup again. If the error persists,
contact your sales agent to examine the CD-ROM drive.
Failed to setup in detail for network adapter.
→ The detailed setup of network adapter is not available in setup of NEC
Express5800/ft series. Open the control panel after starting Windows Server 2003,
Enterprise Edition to configure the network adapter.
Failed to install Windows Server 2003, Enterprise Edition correctly.
Have you checked instructions and information on installation?
→See "INSTALLING Windows Server 2003" on page 3-7.
Rebooted during the setup.
→ See "SWITCHING BOOT MONITORING FUNCTION ~CHANGING BIOS
SETTINGS~" on page 3-2, and configure parameters to make correct BIOS
settings.