NEC Express 5800 User Manual page 114

5-16 Troubleshooting
d-2. Run the following command from Command Prompt and move to CD-ROM
drive.
C:\> CD-ROM drive:
d-3. Run the following command from Command Prompt
with the batch file.
CD-ROM drive:\> cd\WINNT\D
d-4. Run the following command
CD-ROM drive:\WINNT\DOTNET\EN> N810484.BAT
d-5. The message of update completion will be display
"[Update of the driver Com
Press any key and terminate."
e) When N8104-103 (1000BASE-T Adapter) is connected
e-1. Execute [C
e-2. Run the following command from Comm
drive.
C:\> CD-ROM drive:
e-3. Run the following command from Command Prom
with the batch file.
CD-ROM drive:\> cd\WIN
e-4. Run the
CD-ROM drive:\WINNT\ DOTNET\EN > N
e-5. The message of update completion will be disp
"[Update of the driver Completion]
Press any key and terminate."
10.
Reboot the system.
11.
After the system has rebooted, log on as an administrator
IMPORTANT:
LEDs of each PCI module are lit green on the front panel of the machine.)
12.
Duplicate the LAN again for both onboard and option boards.
Refer to "SETTING DUAL LAN CONFIGURATION" on page 3-28 or "N
(100BASE-TX Adapter)", "N8104-84 (1000BASE-SX Adapter)" and "
(1000BASE-T Adapter)" in the separate volume of User's Guide.
Configure the LAN based on the memo.
13.
Configure the BIOS settings. Enable [Boot Monitoring] selected in [Monitoring
Configuration] of [Advanced. For more information, see "SWITCHING BOOT
MONITORING FUNCTION ~CHANGING BIOS SETTINGS~" in Chapter 3.
ommand Prompt].
following command from Command Prompt for updating the driver.
Check that the dual system is configured properly. (Confirm STATUS2
OTNET\EN
from Command Prompt for updating the driver.
pletion]
and Prompt and move to CD-ROM
NT\DOTNET\EN
8104103.BAT
layed.
and move to the folder
ed.
pt and move to the folder
8804-001P1
N8104-103