NEC Express 5800 User Manual page 48

3-8 Windows Setup
Size of the Partition to be Created
The required minimum size of a partition to install the system can be obtained from the following
formula:
Size required for installation + paging file size + dump file size
Size required for installation
Paging file size (recommended)
Dump file size
IMPORTANT:
The above paging file size is necessary for collecting debug information (memory dump). If a
value smaller than the "Recommended" value is set for the initial size of the paging file, correct
debug information (memory dump) may not be collected.
The maximum paging file size is 4095MB in a partition. If 1.5 tines the size of mounted
memory is larger than 4095MB, set the size at 4095MB.
If the size of mounted memory is larger than 2GB, the maximum size of dump file is
"2048MB+12MB."
The mounted memory size means the total of memory installed on a single CPU module.
TIPS:
For example, if memory of 512MB is mounted, the required minimum partition size obtained from
the above formula is as follows:
2900MB +(512MB × 1.5)+(512MB +12MB)=4192MB
In the case of ft series setup, you need to create a partition of 3072MB or more to perform
TIPS:
auto installation.
About Auto Installation of Utilities
The ft series setup installs the following utilities automatically.
•
NEC ESMPRO Agent
= 2,900MB
= size of memory mounted* × 1.5
= size of memory mounted* + 12MB