NEC Express 5800 User Manual page 57

After the hard disk drive is formatted, the message about copying the NEC Express5800/ft series
system software to the system drive from the CD-ROM.
Wait about 5 minutes until copying is completed.
Copyright(c) 1989-2002 Datalight, Inc
Formatting 3.07G
100 percent complete
Writing out file allocation table
Complete.
Calculating free space (this may take several minutes). . .
Complete.
Format complete.
System transferred
3,068.90 MB total disk space
114,688 bytes used by system
3,068.79 MB available on disk
4,096 bytes in each allocation unit.
785,606 allocation units available on disk.
Volume Serial Number is XXXX-XXXX
Copying necessary NEC Express5800/ft series system software to the
system drive... Approximately 5 minutes.
7. After finishing copying the software to the system drive, the following message will appear.
Remove the CD-ROM and press Enter. The NEC Express5800/ft series is restarted automatically.
Necessary NEC Express5800/ft series software has been copied.
Remove the CD-ROM from the CD-ROM drive, and press [ENTER] to finish.
The system will reboot from the Hard Disk Drive.
Make sure to remove the CD-ROM from the CD-ROM drive. If the machine
IMPORTANT:
starts up with the CD-ROM inside, the system will be started up from the CD-ROM and NEC
EXPRESSBUILDER will be started.
8. When the NEC Express5800/ft series is restarted, the following message will appear.
Choose one of the following operations:
- If you have "ft Update CD", enter "Y" and go on to step 9.
- If you do not have "ft Update CD" and perform installation only with "NEC
EXPRESSBUILDER", enter "N" and go on to step 10.
If you have an additional ft Update CD and wish to use it,
insert the CD-ROM into the CD-ROM drive.
Use an additional ft Update CD?[Y,N]?
9. When "Y" is entered in step 8, the following message will appear.
Windows Setup 3-17