Download  Print this page

Installing An Optical Disk Drive In The Optical Bay (mini-tower Configuration) - HP Z400 Maintenance And Service Manual

Hide thumbs

Advertisement

Installing an optical disk drive in the optical bay (mini-tower configuration)

To install an optical disk drive:
1.
Power down the workstation (see
2.
Disconnect power from the workstation (see
3.
Remove the side access panel (see
4.
Remove the airflow guide (see
5.
Remove the front bezel (see
6.
Remove the bezel blank where you want to add the drive.
7.
Install the four black metric M3 guide screws into the sides of the drive.
8.
Lift the green release lever (1), align the screws with the grooves in the drive bay, and gently slide
the drive into the bay until it snaps into place (2)..
CAUTION:
drive to see if it can be disengaged. Failure to properly secure the drive can cause damage to the
drive when moving the workstation.
Figure 5-17
9.
Connect the power and data cables to the drive as shown in the following figure. (See the service
label on the side access panel for component locations in your model of Z400.)
ENWW
Predisassembly procedures on page
Removing the side access panel on page
Removing the airflow guide on page
Removing the front bezel on page
Ensure that the optical drive is secure in the workstation chassis by pulling on the
Installing the optical disk drive
Predisassembly procedures on page
83).
Removing and installing components
75).
75).
78).
110).
91

Advertisement

Table of Contents

   Related Manuals for HP Z400

Comments to this Manuals

Symbols: 0
Latest comments: