Installing An Optical Disk Drive In The Optical Bay (Mini-Tower Configuration) - HP Z400 - Workstation Maintenance And Service Manual

Installing an optical disk drive in the optical bay (mini-tower configuration)

To install an optical disk drive:
1. Power down the workstation (see
2. Disconnect power from the workstation (see
3. Remove the side access panel (see
4. Remove the airflow guide (see
5. Remove the front bezel (see
6. Remove the bezel blank where you want to add the drive.
7. Install the four black metric M3 guide screws into the sides of the drive.
8. Lift the green release lever
release latch as shown in the figure below.
Figure 5-15
9. Release the latch and continue sliding the drive until the latch closes and engages the drive
TIP:
align both devices to get the release latch to close and engage both devices.
10. Connect the power and data cables to the drive as shown in the following figure. (See the service
label on the side access panel for component locations in your model of Z400.)
82 Chapter 5 Replacing components
Removing the front bezel on page
Installing the optical disk drive
During installation, the adjacent drive or filler may move slightly. You may have to slide and
Predisassembly procedures on page
Predisassembly procedures on page
Removing the side access panel on page
Removing the airflow guide on page
and slide the optical disk drive into the bay until it is stopped by the
69).
69).
72).
92).
75).
.
2
ENWW