Resetting Network Setup Values To Default; Resetting All Printer Default Settings (Postscript Nvram); Service Diagnostics Postscript Nvram Resets - Xerox 7300B - Phaser Color Laser Printer Service Manual

Note: Print a Configuration Page to provide a reference of the
current network settings prior to using any of the following
resets.

Resetting Network Setup Values To Default

Resetting the network setup values resets the TCP/IP address, TCP/IP address menu
settings (gateway, broadcast, etc.), CentreWare IS, EtherTalk, Netware, set IPX frame
type, IPP and Ethernet speed to their default values.
1. From the Main Menu, highlight
2. Highlight
Reset Connection Setup
3.
Reset Connection Setup NOW

Resetting All Printer Default Settings (PostScript NVRAM)

Resetting the NVRAM restores all printer values stored in the IP controller NVRAM
including network, printer setup, job defaults, color, margin, and calibrations to their
factory default values. The print counts and the Adobe firmware serial number are not
affected by this reset
1. From the Main Menu, highlight
2.
Highlight
Service Tools Menu
3.
Reset NVRAM
4. Highlight
Reset NVRAM and Reset Printer NOW
the settings to their factory default values.

Service Diagnostics PostScript NVRAM Resets

Resetting NVRAM restores all printer values stored on the Image Processor Board
NVRAM including printer setup, job defaults, color, margin, and calibrations to their
factory default values. The consumable counts, network settings, and the Adobe
firmware serial number are not affected by this reset.
1.
Enter Service Diagnostics.
2. Highlight
NVRAM Access
3. Highlight
PostScript NVRAM Reset
4.
Resetting NVRAM! Are you sure?
5. The printer will exit Service Diagnostics, reboot, and reset the NVRAM.
4-124
Connection Setup Menu
Support
is displayed, press OK.
and press OK.
and press OK.
is displayed, press OK.
and press OK.
and press OK.
and press OK.
is displayed, highlight
Phaser 7300 Color Printer Service Manual
and press OK.
and press OK to reset all
and press OK.
Yes