HTTP-SSL/TLS feature is available only when a digital certificate is set from the Dell Printer Configuration Web Tool.
IP Filter feature is available only for
To block data received from certain IP addresses through the wired or wireless network. You can set up to five IP
addresses. The change becomes effective after the printer is turned off and then on again.
No. n / IP Address (n is 1–5.)
No. n / Mask (n is 1–5.)
No. n / Mode (n is 1–5.)
IEEE 802.1x feature is available only when the printer is connected using LAN cable and it is available only when the IEEE
802.1x authentication is enabled.
To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off and then on
To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting
the printer, all wired network settings are reset to their default values.
To specify PostScript communication protocol for a parallel interface, you can configure the Adobe Protocol
settings for the wired network. The change becomes effective after the printer is turned off and then on again.
Used when auto-detecting the PostScript communication protocol.
Used when the communication protocol is in ASCII interface.
Used when the communication protocol is in binary format.
Used when the communication protocol supports both ASCII and binary data to switch between them
according to the specified control code.
Used when no special processing is required for data.
Use the USB Settings menu to change printer settings affecting a USB port.
USB Port feature is available only for the USB port on the rear of the printer.
Sets the IP address for Filter
Sets the address mask for Filter
Disables the IP Filter feature for Filter
Accepts an access from the specified IP address.
Rejects an access from the specified IP address.
Understanding the Printer Menus