Dell C3760dn Color Laser Printer User Manual page 180

Substitute Tray
*3
Letterhead 2 Sided
Low Toner Alert Message
Use Another Tray
Apply New Settings
Restart printer to apply new settings
*1
When you specify 1 minute for Sleep, the printer enters power saver mode 1 minute after it finishes a job. This uses much less energy,
but requires more warm-up time for the printer. Specify 1 minute if your printer shares an electrical circuit with room lighting and you
notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to operate with minimum
warm-up time.
Select a value between 1 and 60 minutes for the power saver mode if you want a balance between energy consumption and a shorter
warm-up period.
The printer automatically returns to the standby mode from the power saver mode when it receives data from the computer. You can
also return the printer to the standby mode by pressing the
*2
Auto-Off Timer feature is available only in certain regions.
*3
This item is available only for Dell C3760dn Color Laser Printer.
*4
This item is available only when the optional 550-sheet feeder is installed.
*5
This item is available only when the optional 512MB memory module is installed, and also when the optional hard disk is not installed.
178
Understanding the Tool Box Menus
Off
Larger Size
Nearest Size
Use MPF
Disable
Enable
On
Off
On
Off
No tray size substitute accepted.
Substitutes paper of next largest size. When there is no
larger paper size, the printer substitutes paper of nearest
size.
Substitutes paper of nearest size.
Substitutes paper from the MPF.
Does not print on both sides of a sheet of letterhead paper.
Prints on both sides of a sheet of letterhead paper.
Shows the alert message when the toner is low.
Does not show the alert message when the toner is low.
Sets to show a message to select another tray when the
specified paper is not available in the paper tray.
Does not print on other paper sizes in other paper trays if
the paper size specified in the job is not available.
After you change the settings, click this button to apply
the changes.
Click this button to apply the changes.
(Power Saver) button on the operator panel.