Usb Settings - Dell 3130cn - Color Laser Printer User Manual

USB Settings

Use the USB Settings menu to change printer settings affecting a USB port.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Port Status
Purpose:
To enable or disable the USB interface. The change becomes effective after the printer is turned off and then on again.
Values:
Enable* The USB interface is enabled.
Disable The USB interface is disabled.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for USB interface. You can configure the Adobe Protocol settings for the
wired network. The change becomes effective after the printer is turned off and then on again.
Values:
Auto Used when auto-detecting the PostScript communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
Used when the communication protocol supports both ASCII and binary data to switch between them
TBCP*
according to the specified control code.
Binary Used when no special processing is required for data.
System Settings
Use the System Settings menu to configure a variety of printer features.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
PowerSaver Time
Purpose:
To specify the time for transition to power saver mode.
Values:
Mode1 5min.*
Specifies the time for transition to Power Saver Mode 1 and Power Saver Mode 2 in minutes.
5-60min.
6min.*
Mode2
1-6min.
Enter 5 to put the printer in power saver mode five minutes after it finishes a job. This uses much less energy, but
requires more warm-up time for the printer. Enter 5 if your printer shares an electrical circuit with room lighting and you
notice lights flickering.